Pressure Release and Spout Cleaning Tool

This management tool is used when inserting a liquor control system pour spout into a full bottle. Because the breather tube is submerged into liquor when the spout is inserted into a full bottle, this specially designed magnet opens the valve inside the spout to allow any air pressure built up to escape so the spouts do not leak.

Simply hold the large gray end of the tool and press down on the spout when inserting the pourer into the neck of the bottle. It's that easy!

This tool is also used to clean the springs and valves on the inside of the control spouts. When the spout is off the bottle, insert it into the base of the tool and hold the top gray opening under a sink faucet. Run hot water through the pourer for about 10 seconds and then remove the pourer from the tool. Shake the water from the spout, dry with a towel and reapply to a new bottle using the tool as described above.

This is a must-have for managers using an electronic liquor dispensing system.